Malkoff Wildcat V6 Flashlight


Malkoff Devices Wildcat Flashlight.  The Cool Variant produces produces 1600(measured) Out The Front Lumens at turn on and 1500 (measured) continuous Out The Front Lumens. 

The Neutral Variant Hi-CRI (90 CRI) produces 1300 (measured) Out The Front Lumens at turn on and 1100 (measured) continuous Out The Front Lumens.

Use the Buttons above to Choose Tint, Body Size, Tailcap, and Head Only Options.  

To Choose the Head Only Option, Be Sure to Click on the No Tailcap or Body Option.  Otherwise it Will Show as Unavailable.

The Flashlight utilizes a 20 degree Frosted Optic.  The Lux is 7000 at one meter (cool) and 5200 (neutral).  This is a real room/warehouse lighter.  The LED is a Cree XHP50.  It will easily light objects at 200+ feet.  It has a High/Low Switch installed and ready to go.  The High/Low output is controlled by head rotation.  The low output is approximately 20-30 lumens depending on batteries used.  The On/Off switch is a forward clicky with momentary function.

The input voltage is 7 - 12 Volts. 

The current draw at 7.4v is 2000ma.

The current draw at 12v is 1200ma.

It can use three to four primary lithium CR123 batteries or two Li-ion rechargeable batteries.  It will work on 3 Li-ion rechargeable cells, but the high/low function will not work properly.  The runtime on high is approximately 1 hr 15 minutes minutes with two 3500 mah 18650's.  Three CR123 primaries will provide about 15-20 minutes of continous full output.  Four CR123 primaries will provide about 45 minutes full output runtime.

With the MD3 Body it is 6  1/4 inches in length with a 1 inch body diameter and 1.22 inch head diameter.  With the MD4 Body it is 7  3/4 inches in length.

It is constructed of 6061 T6 Aluminum with Type III Black HA finish.  It is fully O-Ringed for weather tightness.  A shatter resistant Acrylic Lens is included.

This Head was designed for rugged service from the ground up.  It is fully potted to stand up to rough service and recoil.

Things to Know Before Purchase:

The input voltage is 7 to 12 volts.  Exceeding 14v may damage the head

The head is protected against reverse polarity.

This light is capable of causing eye damage at close range.  Please use the light responsibly!!!

Caution the Head of the Light WILL GET HOT (180* F after 30 minutes still air, ambient 74* F) during continuous use!!!  Please use safety precautions.  The temperature will be much lower if the light is hand held or mounted in a metal clamp.

Battery Warnings for Li-ion Cells (Not Included):

- Do Not overdischarge/overcharge

- Please recharge drained batteries ASAP

- Do Not short circuit

- Do Not dispose of in fire

- Do Not expose to extreme heat or water

- Please be familiar with the handling of Lithium-ion batteries prior to purchase

Made in the USA. Some parts not domestically sourced.

This item is covered by our Lifetime Warranty.