This flashlight is all about throw. It has a tightly focused beam with a reasonable spill. The output is approximately 700 measured Out the Front lumens on high and 50 OTF lumens on low. The High/Low is controlled by head rotation. The On/Off switch is a forward clicky with momentary function.
This flashlight will illuminate objects at 1200+ feet. The Lux at one meter is approximately 90,000 (many artifacts on a white wall). The Lux with a 1 degree diffuser is 70,000 (some artifacts on a white wall). The Lux with a 5 degree diffuser is 35,000 (no artifacts on a white wall). The tint is 5700K.
This Flashlight is Designed for Maximum Reach in a Small Format. If You are a White Wall Hunter, This is NOT the Head For You. It does not have a beautiful, symmetrical beam on a white wall. It has artifacts and rings. The square artifact in the corona is not centered around the hot spot. The hot spot WILL appear to be at the edge of the small square artifact (on a white wall). In real life usage this artifact is hardly noticeable.
This is an artifact and does not cut down on throw. The LED is centered. We do include diffusers for beam smoothing, please note that these will reduce throw. The light does have massive throw for it’s size, but it does come at the expense of an ugly beam.
The included diffusers are constructed of 0.01" thick polycarbonate and should be installed textured side toward the LED, in front of the lens.
The runtime on the included 18650 battery is approximately 1 hour at full output (down to 475 lumens). Then another 45 minutes of bright output (down to 100 lumens) followed by several hours of declining output.
This Flashlight was designed for rugged service from the ground up. It is fully potted to stand up to rough service and recoil.
SAVE 5% (compare to Hound Dog 18650 Head, MD2 Body and Tail Cap, KeepPower Protected 18650 3500ma cell, and Battery Charger)
Black Type III Hard Anodized Malkoff Cool Tint (5700K) Hound Dog 18650 Head.
Black Type III Malkoff MD2 Body and Tail Cap.
Two Diffusers, 1 Degree and 5 Degree.
One KeepPower protected 18650 (Sanyo NCR18650GA Protected Button Top) Battery.
Xtar VC2S Battery Charger and USB Wall Adapter.
Length: 6 inches
Body Diameter: 1 inch
Head Diameter: 1.8 inches
Things to Know Before Purchase:
This Flashlight is Designed for Maximum Reach in a Small Format. If You are a White Wall Hunter, This is NOT the Head For You. It does not have a beautiful, symmetrical beam on a white wall. It has artifacts, some rings, and the hot spot will appear to be at the edge of a small artifact in the corona. This is an artifact and does not cut down on throw. The LED is centered. We do include diffusers for beam smoothing, please note that these will reduce throw.
The maximum input voltage is 6 volts. Exceeding 6v will ruin the head
The head is protected against reverse polarity.
This light is capable of causing eye damage at close range. Please use the light responsibly!!!
- Do Not overdischarge/overcharge
- Please recharge drained batteries ASAP
- Do Not short circuit
- Do Not dispose of in fire
- Do Not expose to extreme heat or water
- Please be familiar with the handling of Lithium-ion batteries prior to purchase
Made in the USA. Some parts not domestically sourced.
This item is covered by our Lifetime Warranty. The Battery is Considered to be a Consumable Item and is Not Covered Unless it is DOA.